Installing Tongue And Groove Flooring Without Nails

One of the cool things about tongue and groove walls is that you can use a technique called blind nailing if you do it properly you won t have any nail heads showing or holes to fill.

Installing tongue and groove flooring without nails.

The traditional method of nailing hardwood tongue and groove flooring is to drive nails at an angle through the tongue of a plank and into the subfloor below but this is time consuming and can. Drive the wedge between the flooring board and a scrap board screwed to the subfloor. If the nail is too short it won t hold the pine tongue and groove securely to the ceiling. When you nail tongue and groove flooring properly the nails are invisible so american floor installers call the process.

Countersink all the nails. Use a rubber mallet and a chisel to pry the tongue and groove tightly together. If installing one half inch pine use 1 1 2 inch nails. Use a circular saw to rip the last board to fit snugly.

The length of the nails is more important than the gauge when using the nails to install tongue and groove wood. Drive the nails through the shoulder of the tongues into the framing at about a 45 degree angle. Screw one wedge to the subfloor and drive the other wedge between the secured piece and the tongue edge of the new flooring piece. Installing tongue and groove flooring.

How to nail down a tongue groove wooden floor without a power nailer. Face nail the first boards in place on the chalk. Cut the wedge from a scrap of flooring with the groove left on. Since one wedge is temporarily fastened to the subfloor and the other wedge is driven between the new piece and the fixed wedge this closes the gap between flooring boards while the screws or nails are set.

Measure the distance from the baseboard or drywall of the far wall from which you plan to start laying the. Wedge bowed boards straight wedge the boards together if necessary to straighten bowed boards. Face nail the last board. Seat the end tongue and groove flooring into each other and push the two boards together for a tight seam.

The nail must be long enough to go through the piece of pine and into the ceiling above. Drive 6d or 8d flooring nails through the pilot holes and then drill additional pilot holes through the tongue at a 45 degree angle spaced as directed by the manufacturer.